Introduction
What TCP/UDP ports need to be open between the VI3 components? The easiest way to do this is via a table / diagram format. This document shows a good diagram to help the discussion: what network ports should I open between VI3 components?
This document has been syndicated from Pete Howard with the source document at http://myitforum.com/cs2/blogs/phoward/
Intended Audience
VMware Certified Professionals (VCPs), and network/security professionals when designing/implementing VI3.
Outline
Diagram of network ports
TBD : Table of rules (inbound/outbound ports by component)
VI3 Network Port Diagram
|
|---|
Click the picture below to see the full example, or go to the source document.
Table of rules TBD
|
|---|
Resources
Authors
|
Jose Ruelas says:
never mind! I went to the source and the ports are there
Jose Ruelas
Steve Chambers says:
in response to: Jose Ruelas
Hehheh! No worries, Jose! That's why we syndicate/link back to the source. The point of syndicating is to not duplicate, but instead highlight great resources out there 
thank you!! great diagram
just to ask: what about iSCSI / NFS ports?
regards from Mexico
Jose Ruelas